Installing a HEI distributor on a Chevy 350 is a simple process that can be completed in a few minutes. The first step is to disconnect the battery ground cable. Next, remove the old distributor cap and rotor. Then, disconnect the coil wire from the old distributor. Now, you will need to remove the two bolts that hold the distributor in place. Once the distributor is removed, you will need to install the new distributor in the same position. Finally, reconnect the battery ground cable and the coil wire to the new distributor.
Advance Tips: How To Install Hei Distributor On Chevy 350
Installing a HEI distributor on a Chevy 350 is a simple process that can be completed in a few hours. The first step is to disconnect the negative battery cable. Next, remove the distributor cap and rotor. To remove the old distributor, loosen the clamp that secures it to the engine and then pull it out.
Now, take the new distributor and insert it into the engine. Make sure that the distributor is seated all the way down. Once it is in place, tighten the clamp to secure it. Now, reconnect the negative battery cable.
The last step is to adjust the timing. First, find Top Dead Center (TDC) on the engine. Once you have found TDC, turn the distributor so that the rotor is pointing to the number one cylinder on the distributor cap. Now, start the engine and let it idle.
Using a timing light, aim it at the harmonic balancer and watch the timing mark. Adjust the distributor until the timing mark is at the correct setting. Once the timing is set, you can replace the distributor cap and rotor.
Conclusion
Assuming you have a Chevy 350 engine, to install the HEI distributor you will need the following: distributor, distributor cap, rotor, coil, spark plug wires, and HEI spark plugs. You will also need a socket wrench and a ratchet.
1. Remove the old distributor. To do this, first disconnect the negative battery cable. Then, remove the distributor cap and the rotor. Next, unscrew the distributor hold-down clamp and pull the distributor out.
2. Clean the engine. To clean the engine, use a degreaser and a brush. Make sure to get all the old grease and grime off of the engine.
3. Install the new distributor. To install the new distributor, first screw the distributor hold-down clamp in place. Next, insert the distributor into the engine and hand-tighten the distributor. Finally, connect the negative battery cable.
4. Install the distributor cap and the rotor.